Objective
make a career change from industrial electrician to an offshore career
Experience
Objective: To continue a career in electrical maintenance with an established company, where my conscientious work ethics, personal intergrity, and a high degree of motivation will contribute to a continued advancement in knowledge and productivity.
Career Experience:
2008-2009 International Paper/Industrial Technical Services
Electrician/Instrument Tech
Supported paper mill in upgrades including the removal and replacement of control panels. This service included the installation upgrade of systems controlling operation of various machines. This service also included the set0-up and calibration of associated instruments.
2007 Mississippi River Corporation
Maintenance Electrician/Instrument Tech
Maintained the nations only food-grade pulp mill in the nation. Performed duties such as troubleshooting, installation and termination of a.c. and d.c. motors including their respective MCC’s. Duties also included installation and calibration of various instrumentation including pressure, temperature, and ph transmitters. Removed, replaced, and calibrated various types of valves with their respective actuators.
2004 Delta Process Equipment
Electro-Mechanical Technician
Performed electrical and mechanical repair on submersible grinder pumps, including their respective controls. Served as warranty repair technician for Barnes Pumps, Inc. Duties included replacement of motors, motor bearings, and mechanical seals. Also served as primary field technician.
2003 Edwards Electric Service
Start up technician; Cement plant
Duties included check-out and commissioning of instrumentation, high and low voltage motors and their associated controls. Duties also included reading of prints and schematics for trouble shooting purposes. Assisted clients with plant operation until job completion.
2002 Nepco
Journeyman Electrician; Steam Power plant
Duties included but not limited to termination of instrument cables, both field-
side and I/O cabinet. Make-up and termination of high and low voltage motors
and transformers. Complete layout of motor and chemical skids including installation of conduit, junction boxes, transformers and associated supports.
1999-2001 Friede-Goldman Offshore
Marine Instrumentation Commissioning Technician; Oil rig
Served as commissioning technician, mainly for instrumentation, but also for
various other electrical systems. My duties also included in the direct support
of several vendors during commissioning procedures. I was also solely
responsible for the calibration and commissioning of all hydraulic and pneumatic valves and actuators inside both pontoons of the oil rig which I was assigned
1996-1999 United States Marine Corps
Navigational Electronics Technician
Responsibilities included the electronic maintenance of sophisticated govern- ment navigational equipment. Troubleshooting electronic equipment down to the module and component level. Repairing circuit boards, soldering and desoldering micro components, and final calibration. I was also responsible
for the ordering and maintaining inventory of parts and electronic supplies. Additional duties performed were the training and instruction of students in my area of expertise. I was also awarded a letter of commendation by the commanding officer of Naval Air Station Pensacola for my duties performed while stationed there.
Education:
Northway Christian Academy Mobile, AL 1996
USMC Parris Island, SC 1996
Continuing Education:
Avionics Common Core Course
a) Aviation Fundamentals
b) Basic Electrical/Electronic Concepts and D.C. Theory
c) A.C. Theory and Introduction to Digital Electronics
Avionics Technician Intermediate Level Course
a) Mathematics for Electronics, A.C. and D.C. Circuit Analysis
Miniature Component Repair Course
Marine Air Traffic Control Technician Common Core
a) Advanced Solid State Devices
b) Advanced Digital Logic
c) Integrated Circuits
d) Troubleshooting Digital Circuits
Marine Air Traffic control Navigational Aids Technician Course
a) Navigational Electronics
Education
Certification
Skils